How To Drain Power Steering Fluid Cms21?

How to Drain Power Steering Fluid (CMS21)

Power steering fluid is an important part of your car’s steering system. It helps to lubricate the pump and other components, and it also helps to cool the system. Over time, power steering fluid can become contaminated with dirt and debris, which can lead to decreased performance and even damage to the system.

Draining and replacing the power steering fluid is a relatively simple task that can be completed in about 30 minutes. It’s a good idea to do this every 30,000 miles or so, or whenever you notice a decrease in steering performance.

In this article, we’ll show you how to drain and replace the power steering fluid in your car. We’ll also provide some tips on how to keep your power steering system in good working order.

So if you’re ready to learn how to drain power steering fluid, read on!

Step Action Notes
1 Locate the power steering fluid reservoir It is usually located on the passenger side of the engine block.
2 Turn the ignition key to the “On” position without starting the engine This will allow the power steering pump to build pressure in the system.
3 Locate the power steering fluid drain plug It is usually located on the bottom of the reservoir.
4 Place a drain pan under the drain plug This will catch the old fluid as it drains out.
5 Loosen the drain plug and allow the old fluid to drain out Be careful not to spill any fluid.
6 Once all of the fluid has drained out, tighten the drain plug Do not overtighten the plug.
7 Add new power steering fluid to the reservoir Add the fluid until it reaches the “full” mark on the reservoir.
8 Start the engine and turn the steering wheel from side to side This will circulate the new fluid through the system.
9 Check the fluid level and add more fluid if necessary The fluid level should be between the “full” and “add” marks on the reservoir.

How To Drain Power Steering Fluid Cms21?

Power steering fluid is a hydraulic fluid that helps to lubricate and cool the power steering system. It also helps to reduce friction between the steering gear and the steering rack. Over time, power steering fluid can become contaminated with dirt, debris, and other contaminants. This can lead to decreased performance of the power steering system and can even cause damage to the system.

Draining and replacing the power steering fluid is a relatively simple task that can be completed in about 30 minutes. It is a good idea to drain and replace the power steering fluid every 30,000 to 50,000 miles or as recommended by your vehicle’s owner’s manual.

Tools and Materials

  • Power steering fluid drain pan
  • Funnel
  • Wrench
  • Rags
  • Safety glasses

Step-by-step Instructions

1. Park your vehicle on a level surface and turn off the engine.
2. Engage the parking brake.
3. Locate the power steering fluid reservoir. It is typically located on the passenger side of the engine compartment.
4. Remove the cap from the power steering fluid reservoir.
5. Use a funnel to add about 1 quart of new power steering fluid to the reservoir.
6. Locate the power steering fluid drain plug. It is typically located on the bottom of the power steering pump.
7. Place the drain pan under the drain plug.
8. Use a wrench to loosen the drain plug.
9. Allow the old power steering fluid to drain into the drain pan.
10. Once all of the old power steering fluid has drained, tighten the drain plug.
11. Add 1 quart of new power steering fluid to the reservoir.
12. Start the engine and turn the steering wheel from side to side. This will circulate the new power steering fluid throughout the system.
13. Check the power steering fluid level and add more fluid if necessary.
14. Dispose of the old power steering fluid according to local regulations.

Draining and replacing the power steering fluid is a relatively simple task that can be completed in about 30 minutes. It is a good idea to drain and replace the power steering fluid every 30,000 to 50,000 miles or as recommended by your vehicle’s owner’s manual. By following these steps, you can help to keep your power steering system in good working order.

Here are some additional tips for draining and replacing the power steering fluid:

  • Make sure that the engine is cool before you begin.
  • Wear safety glasses to protect your eyes from any spills.
  • Use a funnel to prevent spills when adding new power steering fluid to the reservoir.
  • Dispose of the old power steering fluid according to local regulations.
  • If you are not comfortable draining and replacing the power steering fluid yourself, take your vehicle to a qualified mechanic.

How to Drain Power Steering Fluid CMS21

Power steering fluid is a vital part of your vehicle’s steering system. It helps to lubricate the power steering pump and assist in the smooth operation of the steering gear. Over time, power steering fluid can become contaminated with dirt, debris, and moisture. This can lead to a number of problems, including decreased steering performance, increased wear and tear on the steering system, and even damage to the power steering pump.

To prevent these problems, it is important to regularly drain and replace the power steering fluid in your vehicle. This is a relatively simple task that can be completed in about 30 minutes. However, it is important to follow the steps carefully to avoid damaging the power steering system.

Tools and Materials

To drain and replace the power steering fluid in your vehicle, you will need the following tools and materials:

  • A 17mm wrench
  • A 10mm wrench
  • A funnel
  • A drain pan
  • New power steering fluid
  • Rags

Step 1: Park the Vehicle on a Level Surface and Turn Off the Engine

The first step is to park the vehicle on a level surface and turn off the engine. Allow the engine to cool down completely before proceeding.

Step 2: Engage the Parking Brake

Engage the parking brake to prevent the vehicle from rolling while you are working.

Step 3: Locate the Power Steering Fluid Reservoir

The power steering fluid reservoir is typically located on the passenger side of the engine compartment. It is a clear plastic reservoir with a cap that is usually marked “power steering fluid” or “PSF.”

Step 4: Remove the Power Steering Fluid Reservoir Cap

Use the 17mm wrench to remove the cap from the power steering fluid reservoir. Be careful not to spill any fluid.

Step 5: Locate the Power Steering Fluid Drain Bolt

The power steering fluid drain bolt is typically located on the bottom of the power steering pump. It is a 10mm bolt that is usually capped with a rubber plug.

Step 6: Remove the Power Steering Fluid Drain Bolt

Use the 10mm wrench to remove the power steering fluid drain bolt. Be careful not to drop the bolt into the drain pan.

Step 7: Allow the Power Steering Fluid to Drain

Allow the power steering fluid to drain completely. This may take a few minutes.

Step 8: Reinstall the Power Steering Fluid Drain Bolt

Once the fluid has drained completely, reinstall the power steering fluid drain bolt. Tighten the bolt until it is snug.

Step 9: Add New Power Steering Fluid

Use the funnel to add new power steering fluid to the reservoir. Fill the reservoir to the “full” line.

Step 10: Start the Engine and Check for Leaks

Start the engine and let it run for a few minutes. Check for any leaks around the power steering fluid reservoir or drain bolt.

That’s it! You have now successfully drained and replaced the power steering fluid in your vehicle. By following these steps, you can help to keep your vehicle’s steering system in good working order.

Here are some additional tips for maintaining your power steering system:

  • Check the power steering fluid level regularly and add fluid as needed.
  • Inspect the power steering hoses for leaks and replace them as needed.
  • Have the power steering pump and steering gear inspected and serviced regularly.

By following these tips, you can help to extend the life of your vehicle’s power steering system and ensure that it operates smoothly and efficiently.

How To Drain Power Steering Fluid Cms21?

Q: What do I need to do before I start?

A: Before you begin, make sure you have the following items:

  • A drain pan
  • A funnel
  • New power steering fluid
  • A 10mm wrench
  • A Phillips head screwdriver

Q: How do I drain the power steering fluid?

A: 1. Park your vehicle on a level surface.
2. Turn off the engine and allow it to cool down.
3. Engage the parking brake.
4. Locate the power steering fluid reservoir. It is typically located on the driver’s side of the engine compartment.
5. Remove the cap from the reservoir.
6. Place the drain pan under the power steering fluid pump.
7. Locate the drain plug on the power steering fluid pump. It is typically a 10mm bolt.
8. Use the wrench to loosen the drain plug.
9. Allow the fluid to drain into the pan.
10. Once all of the fluid has drained, replace the drain plug.
11. Refill the power steering fluid reservoir with new fluid.
12. Tighten the cap on the reservoir.

Q: What type of fluid do I need to use?

A: You will need to use the same type of fluid that is specified in your vehicle’s owner’s manual.

Q: How much fluid do I need to add?

A: Add enough fluid to bring the level to the “full” mark on the reservoir.

Q: What if I overfill the reservoir?

A: If you overfill the reservoir, you will need to remove some of the fluid. Use a turkey baster or a small funnel to remove the excess fluid.

Q: What are the signs of a power steering fluid leak?

A: Signs of a power steering fluid leak include:

  • Low power steering fluid level
  • A whining or groaning noise from the power steering pump
  • A fluid leak under the vehicle

Q: How do I fix a power steering fluid leak?

A: If you have a power steering fluid leak, you will need to take your vehicle to a qualified mechanic to have it repaired. The mechanic will be able to identify the source of the leak and repair it accordingly.

In this blog post, we have discussed how to drain power steering fluid on a CMS21. We have covered the steps involved in the process, as well as some tips and tricks to make the job easier. We hope that this information has been helpful, and that you are now able to drain the power steering fluid on your CMS21 safely and effectively.

Here are some key takeaways from the blog post:

  • Power steering fluid is a vital part of your car’s steering system, and it is important to keep it topped up and in good condition.
  • To drain the power steering fluid on a CMS21, you will need to locate the power steering reservoir, remove the reservoir cap, and drain the fluid into a drain pan.
  • Be sure to replace the reservoir cap and fill the reservoir with the correct type of power steering fluid.
  • If you are not comfortable performing this task, you can take your car to a qualified mechanic.

Author Profile

Against Austerity
Against Austerity
Previously, our website was dedicated to the work of United Front Against Austerity (UFAA). Focused on addressing the economic challenges in the United States, UFAA was committed to fighting against austerity measures that threatened essential social programs. The group emphasized the need for substantial financial reforms to alleviate the economic depression, highlighting two key demands: Implementing a 1% Wall Street Sales Tax and Nationalization of the Federal Reserve System.

In 2023, our website underwent a significant transformation, pivoting from its previous focus on economic and political advocacy to becoming a resource for empowering people through information. Recognizing the evolving needs of our audience, we shifted towards providing in-depth, informative articles that address pressing questions and queries from various fields.

Our website’s transformation is a reflection of our commitment to providing valuable, in-depth information that empowers our readers. By adapting to changing times and needs, we strive to be a trusted source of knowledge and insight in an increasingly complex world.